In this video, we choose a 3D Printer, modify it to run from our DC Solar Power supply, and build it into the storage compartment of our self-built, self-sufficient, Overland Truck. "Building" and "Making" is in my DNA and when I find a problem or something that can be made better, I can't sleep until I fix it, either in our truck or rigs of friends we make along the way. And while we carry two extra of everything we used to build the truck and a good selection of tools, bubblegum, and duct tape - this only gets you so far. It's sometimes hard to whittle something out of nothing or shape bubblegum into a complex IPR wrench. (https://www.thingiverse.com/thing:3246049) This is the Ender 3 V2 I ordered: https://amzn.to/3nXRndW So in this video, we install a 3D printer, reinforce it for the rigors of life on the road, and power it with a DC-DC converter to run from our Lithium and Solar. I'll show an Introduction, the very basics of 3D printing, and show a handful of parts we've made already. 10 points to the person who can spot the unmentioned 3D print hiding in plain sight. 0:00 Welcome! 0:14 The Backstory and why I need it... 2:15 EPIC Unboxing of our Ender 3 V2 3:07 Changes I've made to the Printer 5:35 Where we're installing it... 7:35 Final Installation 10:14 Dangling Raspberry Pi's 12:55 Overview of Usage 14:40 Parking the Head and Gantry on a Foam Block 16:27 Designing a part to support the Raspberries and Printing it 19:50 Design and Print a Bulkhead Fitting/Wire Gland? 23:40 Printed Case for TS100 Soldering Irons 24:12 12 Volt Wall Plate Adaptor 1000™ 24:29 Printed Caes for Step Up Converters 25:07 LoRa Meshtastic 3D Printed Cases 25:43 Anti-Death Machine Tube Guides 27:07 3D Printed case for Calipers 27:23 Pump Switch Mount 27:40 Camper Fridge Vent Fan Adaptor 28:22 PETG Hiking Pole mounting Clips I will be posting many of the designs for the 3D printed parts you see in this video here: https://www.thingiverse.com/everlanders/designs The Hiking Pole Mounts can be downloaded here: https://www.thingiverse.com/thing:4746151 My Compact Screen Mount Spacer is here: https://www.thingiverse.com/thing:4746101 The X-axis Tension Delete is here: https://www.thingiverse.com/thing:4746681 The Hotend Fan Mount I'm using: https://cults3d.com/en/3d-model/tool/ender3-v2-dual-40mm-fan-hot-end-duct-fang If you'd like 20% off the Froli Bed Springs we use and LOVE, use this code to check them out: https://nickleatlantic.com/discount/EV If you'd like to drop a few pesos in the Sombrero for Fuel or Camera Gear, please consider becoming a member of the channel. For more information Click Here: https://www.youtube.com/everlanders/join Get a DJI drone here: https://click.dji.com/AF7icN8Hg2BxV6XcG8lW8Q?dji_from=dji-pilot-app&pm=dji-pilot-app